![]() ![]() All of the rest can just have default routes. The only router that needs to know explicitly how to reach any of the 10.x.x.x routes is the central router at the top of your diagram. ![]() ![]() So instead of having a route to 20/8 and 30/8 on the subnet routers, you could just put a route to 0.0.0.0/0 pointing to 192.168.1.2 on the first router, 192.168.2.2 on the second one, and 192.168.3.2 on the third. Example 6-18 Verifying the OSPFv3 Routing Table on R1 R1 show ipv6 route ospf IPv6 Routing Table. In fact, you can eliminate the routes on the subnet routers, too, and just give them a default gateway to the central router. Scalin Networ Compan Gui Cisco Networking Academy. The "default gateway" is really just a route to 0.0.0.0/0 which means "the rest of the IP address space that I don't have a more specific route for". Examples: Catalyst 6500 Series Switches 7600 Series Routers. Or, default routing in cisco packet tracer mean Default static route. Router Configuration With Cisco Packet Tracer. This tells the PC "when I have a packet that must go to a destination that is not on my own network, send it to 10.0.0.1, and that device will know what to do with it". Open the packet tracer and create an example LAB as shown in the following image. So the subnet router port in the first network would have the address 10.0.0.1 and the PC would have 10.0.0.2 and the default gateway would point to 10.0.0.1. The default gateway of each PC needs to be the same as the subnet router port IP in its network.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |